Thing$ You Can Paint Instead of Replace to $ave Money

7 Things You Can Paint Instead of Replace to Save Money

You know a fresh coat of paint can give any room a quick and inexpensive facelift. But did you know that a little paint can also perk up carpets, appliances, and even vinyl floors?

Basically, if it doesn’t move, you can paint it. But only after you’ve paid special attention to prep — cleaning, patching, and sanding (generally) the area.

Painting isn’t brain surgery, but it’s not a breeze, either. Here are some rules of thumb:

• Prime before painting. Primer will allow the paint to adhere better.

• Most hard surfaces will take primer better if they’re roughed up a little with fine-grade sandpaper.

• When using spray paint, multiple, thin layers are better than one, thick coat. Ease up on your trigger finger, and spray in short bursts.

• Wait for the previous coat of paint or primer to dry completely before adding another coat.

With proper prep, you can paint just about anything. Here are seven of our favorite ideas:

1. Door, Drawer, and Cabinet Hardware

Spray paint can turn builder-grade brass locks and hinges into fashion-forward hardware with an oil-rubbed bronze, pewter, or stainless look.

Prep:

1. Clean hardware with a fine steel wool to remove grease and grime.
2. Rough up the surface with fine-grain sandpaper.
3. Before you paint, insert a tiny strip of painter’s tape into the keyhole to make sure paint doesn’t gunk it up.
4. Prime with a metallic primer, then paint with metallic spray paint.

Tip:

• Insert the door lock’s spindle into a square of Styrofoam, which will hold it upright while you spray around the knob.

2. Brick Fireplace

When you paint your red brick fireplace, you transform the entire room. But beware! Once you paint brick, it’s nearly impossible to return it to the original brick color.

You can paint brick a single color, or achieve some variation — like the variations in real brick — by sponging on slightly lighter and darker hues.

Prep:

1. Lightly sand away any loose bits of brick or mortar with 120-grit sandpaper.
2. Clean dirt and soot with a wire brush and heavy-duty cleanser.
3. Allow to dry completely before applying an oil-based, stain-blocking primer.
4. Paint with a semigloss latex.

Tips:

• Never paint the firebox.

• Brick is porous and drinks paint, so buy twice what you think you’ll need.

• Wear safety glasses and gloves when cleaning anything with a metal brush.

3. Ceramic Tile

Imagine how sweet it is to update ceramic tile without having to bust up and cart away tons of old tile.

Play it safe and avoid painting tiles in high-traffic and high-moisture areas. Some good places are laundry room floors, backsplashes under cabinets (but not above ranges where pasta sauce splatters), and walls around tubs you rarely use.

Prep:

1. Repair cracked or chipped tile with caulk or grout before painting.
2. Give patching material ample time to dry, then lightly sand before applying an epoxy or urethane bonding primer.
3. Sand after priming and between each coat of quality latex paint.
4. Wait several days for the paint to cure completely, then seal with two or three coats of clear, water-based polyurethane.

Tips:

• To get a smooth look, apply paint in zigzags, then roll down in one, smooth motion.

• Use 240-grit wet/dry sandpaper for prep and between coats.

• Don’t forget safety goggles and masks when sanding tiles.